Skip to content
Gaming

Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (Ayaneo Air 1S)

Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC explained, with the Ayaneo Air 1S's own measured figures as the worked example: the codec determines how audio is compressed for transmission. I...

Tech Daily Review Desk 4 min read 5,859 views
Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (Ayaneo Air 1S)

In brief

Ayaneo Air 1S, play time 2h 05m in demanding titles — Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC. Measured on hardware rather than argued from theory, on a device we rate for strong performance for the size.

The codec determines how audio is compressed for transmission. It matters less than fit and tuning, but it is not nothing.

Why this matters: Codec support is one of the few hard compatibility facts worth checking before buying wireless audio.

How it actually works

SBC is the mandatory baseline every device supports. AAC is efficient and what Apple devices use. aptX variants target lower latency. LDAC carries the most data but needs a supporting source and drops back under interference. A codec sets a ceiling on quality; it does not guarantee it.

What it looks like in practice

Take the Ayaneo Air 1S as a worked example. It is 190g lighter than the Steam Deck OLED. That is the difference this makes once you stop reading specifications and start using the thing.

SpecificationAyaneo Air 1S
Display5.5in OLED, 60Hz, 400 nits
ChipAMD Ryzen 7 7840U
RAM16GB LPDDR5
Storage512GB NVMe
Weight450g
Battery38Wh
Play time2h 05m in demanding titles

How it varies across the category

One worked example is an anecdote. Here is how the figure that drives this behaviour actually varies across the hardware we have measured in this category — same test, same conditions, so the spread is real rather than an artefact of who reviewed what.

ModelDisplayPriceOur score
Ayaneo Air 1S5.5in OLED, 60Hz, 400 nits£6493 / 5
Steam Deck OLED7.4in OLED, 90Hz, 1000 nits HDR£4795 / 5
ROG Ally X7in IPS, 120Hz, 500 nits£7994 / 5
Switch OLED7in OLED, 60Hz, 400 nits£3094 / 5

Where the line sits

It helps to have a number in mind before you start comparing. Across the gaming Hardware we have measured, the useful thresholds are the ones where a difference stops being visible: below them you notice, above them you are paying for a specification rather than an experience. The Ayaneo Air 1S reports 5.5in OLED, 60Hz, 400 nits for display, which sits comfortably on the right side of that line, and AMD Ryzen 7 7840U for chip. Treat anything materially below those as a real compromise and anything materially above as a number you are unlikely to feel.

What people get wrong

  • LDAC always sounds better, when it drops to lower bitrates under congestion
  • Codec choice matters more than tuning or fit — it does not
  • You can hear the difference on any source material

How to verify this at home

  1. Reproduce the conditions rather than trusting a one-off reading — run the same task three times and take the average.
  2. Note the figure your device reports and the figure it actually achieves; on the Ayaneo Air 1S those diverge under sustained load.
  3. Change one variable at a time. Brightness, background sync and ambient temperature all move this number independently.
  4. Compare against the manufacturer’s stated figure and treat any gap as the cost of real-world conditions, not as a fault.
  5. Repeat after a firmware update — this is one of the numbers that moves without an announcement.

How to use this when buying

Check your phone supports the codec before paying extra for it, and prioritise fit and tuning over the acronym.

Buy for fit and tuning first. Treat the codec as a tie-breaker.

Behind this piece

How we tested this — Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (Aya...
How Tech Daily Review tests the hardware it writes about.

Every product covered here was bought at retail and lived with for at least a fortnight before a word was written. Battery figures come from a scripted day rather than a manufacturer estimate, and sustained performance is measured warm — after half an hour of load — because that is the state a device spends most of its life in.

Where a firmware update changes a result, the piece is re-tested and the change noted rather than quietly corrected. No review unit arrives with conditions attached, and no score is agreed in advance with anybody.

Where to go next

If you are weighing this against the rest of the gaming we have covered, the category archive lists every review in date order. The closest comparisons we have published are Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (Legion Go) and Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (PlayStation 5 Slim).

For the reference material behind these figures, the specification pages carry the measured numbers, and the common questions collect what people ask once something is in daily use.

Frequently asked questions

It can carry more data, but on a congested connection it falls back. On an iPhone it is unavailable anyway, so AAC is the practical ceiling.
Broadly, though the effect is most visible on gaming Hardware like the Ayaneo Air 1S.
Run the same task three times and average the result. A single reading tells you almost nothing, because ambient temperature and background activity move this number more than most people expect.
Frequently, and rarely with an announcement. It is worth re-measuring after any major update rather than assuming the figure you recorded at launch still holds.
Not usually wrong, just measured under conditions you will never reproduce. Treat the gap as the cost of real-world use rather than as a defect.

Tech Daily Review Desk

The shared editorial account. Used for site notices and corrections.

Please login to comment.

Comments (0)

No comments yet.

Keep reading